Carly Bag

Carly Bag

Discover The Lincoln Town Car Air Suspension's Problems And Their Solutions

The Lincoln Town Car's air suspension uses a small, separate air compressor under the driver's side left fender well, with air lines running towards the air bags. On top of each one air bag is a electrical valve. This is a relief valve which allows air to be exhausted when activated, and which senses the amount of air pressure inside the air bag to maintain each side equal.

These valves are operated via a leveling sensor that is attached to the body of the car and to the rear axle by a movable arm. When the rear of the car drops due to increased load, the arm is pushed up. Once the arm is pushed up, it turns on the air compressor and fills the air bags to level the car. Once the load is taken away and also the arm moves down, indicating that the back of the car has risen, the sensor opens the valve on the air bags and allows air to escape, lowering the car.

If the back of the car is low, indicating that the air suspension is not working, and also the air suspension light is on, check the fuse first. If the fuse is all right, check the air suspension switch in the trunk and make sure it is on. This switch is used once the car is in for service. Always turn off the switch before lifting the car, since the sensor will think the car is rising and keep the air bag valves open, ruining the rear air suspension.

Turn the ignition key with the engine off. Listen for the compressor in the future on while pushing down on the rear bumper. If it does not come on, test the switch terminals for power, using a circuit tester. If one terminal has power and the other doesn't, replace the switch. If there is power, turn the switch to the off position, raise the vehicle and place it on jack stands in the rear.

Inspect the leveling switch on the axle, making sure it is not bent and is connected. Use an ohmmeter for this test. Pull the electrical connector off the switch. Loosen the arm of the switch from the axle. Test the switch with the ohmmeter by checking across both terminals while slowly moving the arm. There should be no continuity with the arm down. As the arm is raised, there should be continuity. If not, replace the switch. If there was continuity, connect the arm and the electrical connector.

Put a floor jack under the axle and raise the axle to the point where it is just beginning to lift the car off the jack stand. Turn on the ignition. Turn the air suspension switch to the "on" position. Use the circuit tester to check for power at the leveling switch. If there is power, turn the air suspension switch to "off" and lower the car. Access the air compressor in the front, under the hood, and check the electrical connector for power. If there is power, check for a good ground. If both are good, replace the compressor. If the compressor works and the car does not rise in the back, replace the air bags.

About the Author